Ericsson RBS 2106 Reference Manual page 387

•
•
The functions above are normally used for:
•
•
•
48.3.3 OMT Connection
The following user functions, related to the OMT, are available in the
OMT:
•
•
The functions above are for general purpose use.
48.3.4 Installation Database
The following user functions, related to the IDB, are available in the
OMT:
EN/LZT 720 0008 P2A
2001-11-28
Configurations possible to display, comprise all RBS 2000
products and the configurations as specified for each product.
The following RU and connections are graphically displayed:
−
DXU
−
TRU
−
ECU
−
CDU
−
Local bus
−
CDU bus
−
Number of antenna systems (1 or 3)
Display RBS software revisions, display RU software revisions for
all Main RUs, see Section 48.3.16 Replaceable Unit on page 391.
Display TEI/RU list, display list of TEI and RU Instances for the
CMRU and for the DMRUs with a direct signalling link to the
BSC in the cabinet (see also Section 48.3.16 Replaceable Unit on
page 391).
General purpose (display RBS configuration)
Maintenance (display RBS software revisions)
Installation (display TEI/RU list)
Connect, establish a connection between the OMT and the RBS.
A functionality and compatibility check is performed on RBS and
OMT software versions. If the OMT is connected remotely an
RBS address can be given in order to select one of several RBSes
connected in a multidrop chain. Also a timeslot, which the OMT
uses when established, is given by the operator. The RBS is
scanning for remote OMT link establishment on all 64 kbit/s
timeslots on PCM-A. If the RBS software does not support
scanning for remote OMT link establishment on all timeslots, the
operator has to use TS23, which is the default value. In case of
different versions the OMT operator is informed about this fact
and that all functionality is not supported.
Disconnect, release the connection between the OMT and the
RBS.
© Ericsson Radio Systems AB
— All Rights Reserved —
Operation and Maintenance Terminal
385 (485)