Microscan MS-850 User Manual page 73

For example, <Kc1><Kh1><Ko1><A>
to New Trigger, enables Narrow Margins and resets the data buffers (without saving the
changes for power-on).
Serial Command Status Request
The status of serial commands can be requested by entering the command followed by
a question mark. For example, send
mands KT?, KV?, KW?, KX?, and KU? are used to request the status of groups of serial
commands.
Loss of Communications
Making changes to communications parameters such as Baud Rate, Parity, Stop Bits,
LRC, etc. without corresponding changes in linked device(s) can result in the loss of
menu access. If this should occur, try ESP
Caution Defaulting the scanner will reset all standard configuration parameters except
:
Scanner Type, Scans per Second, and Gain Adjustment to their original default values.
Note Power must be available to the scanner during the default procedure.
:
MS-850 Raster Scanner User's Manual
enables LRC, sets End of Read Cycle mode
<Ke?> to request the status of Postamble. Com-
Auto Baud command or restore defaults.
3-5