Table of Contents
Advertisement
Chapter 2
Menu Configuration
Enabled
When Supplementals is set to Enabled, the UPC main and supplemental label are con-
sidered to be separate labels. Therefore Number of Labels must be set to 2 and a mul-
tilabel separator will be inserted between the label data and the supplemental label
data.
For example, if Supplementals is enabled, Number of Labels is set to 2, and the Multi-
label Separator Character is defined as a #, the data will be displayed as: LABEL #
SUPPLEMENTAL
Attempting to decode two UPC labels with Supplementals enabled is not recom-
mended.
Note
Under no circumstances will a supplemental label be output without a main
:
label.
Note
Do not set Triggering Mode to Continuous Read 1 Output. Enabling Continuous
:
Read 1 Output will cause Number of Labels to default to 1.
Required
When set to Required, the UPC main and supplemental labels are considered to be
one label. If either the main or supplemental label is not read, a single noread mes-
sage will be output.
For example, if Supplementals is set to Required, Separator is enabled, and an aster-
isk is defined as the Separator Character, then the data will be displayed as: LABEL *
SUPPLEMENTAL
Note: If additional labels—other than the main or supplemental—will be read in the
same read cycle, Number of Labels should be set accordingly.
Separator
Default:
Disabled
Options:
Disabled, Enabled
Allows you to insert a character between the standard UPC or EAN code and the sup-
plemental code when Supplementals is set to Required.
Separator (character)
Default:
,
(comma)
Options:
Any ASCII character.
Allows you to change the separator character from a comma to a new value.
2-28
MS-850 Raster Scanner User's Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the MS-850 and is the answer not in the manual?