Polycom SpectraLink 8020 Administration Manual page 66

Spectralink 8000 telephony gateway and spectralink radio protocol (srp)
Hide thumbs Also See for SpectraLink 8020:
Table of Contents

Advertisement

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SRP
Message
CRC Code Error
Code Mismatch!
DHCP Error (1-5)
DHCP Lease Exp.
yyy.yyy.yyy.yyy
DHCP NACK Error
yyy.yyy.yyy.yyy
DL not on sector
66
Description
The software which has been TFTP
downloaded has a bad redundancy
code check.
The software loaded into the handset
is incorrect for this model handset.
DHCP Error 1
DHCP Error 2
DHCP Error 3
DHCP Error 4
DHCP Error 5
y...y = DHCP Server IP address
DHCP is not responding to renewal
attempts (at least one renewal
succeeded).
y...y = DHCP server IP address
DHCP server explicitly refused
renewal.
Handset software download files are
incorrect or corrupted.
Action
Try the download again - it is possible
the software was corrupted during
download. If the error repeats, check
that the download image on the TFTP
server is not corrupted.
Verify the License Management value is
correct. Replace the software image on
the TFTP server with software that is
correct for the handset model.
The handset cannot locate a DHCP
server. It will try every four seconds until
a server is located.
The handset has not received a
response from the server for a request
for an IP address. It will retry until a
server is found.
The server refuses to lease the handset
an IP address. It will keep trying.
The server offered the handset a lease
that is too short. The minimum lease
time is 10 minutes but Polycom
recommends at least one hour
minimum lease time. The handset will
stop trying. Reconfigure the server and
power cycle the handset.
Failure during WEP Key rotation
process (proprietary feature).
The handset failed to renew its DHCP
lease, either because the DHCP server
is not running, or because the
configuration has been changed by the
administrator. The handset will attempt
to negotiate a new lease, which will
either work, or change to one of the
above DHCP errors (1-4).
The DHCP lease currently in use by the
handset is no longer valid, which forces
the handset to restart. This problem
should resolve itself on the restart. If it
does not, the problem is in the DHCP
server.
Download new software from the
SpectraLink site per Chapter 7 Software
Maintenance.
1725-36030-001_B.doc

Advertisement

Table of Contents
loading

This manual is also suitable for:

Spectralink 80308030802 series803 series

Table of Contents