Polycom SpectraLink 8020 Administration Manual page 29

1725-36030-001_B.doc
The IP address of the time server. The time server
Time Server IP
controls the date/time information that is displayed in standby mode.
SSID
Enter the SSID.
Security
Disables any 802.11 encryption or security authentication
*NONE
mechanisms.
For WEP, WPA-PSK and WPA2-PSK set each of the following
options to match exactly the settings in your APs.
Encryption codes display as they are entered. For security reasons,
codes will not display when a user returns to encryption options in
the Admin menu.
(Wired Equivalent Privacy) A wireless encryption protocol that
WEP
encrypts data frames on the wireless medium allowing for greater
security in the wireless network. If WEP is required at this site, you
must configure each handset to correspond with the encryption
protocol set up in the access points. Select the entries from the options
below to enable the handset to acquire the system.
Authentication
Select either
Open System
WEP Enable/Disable
Select either
Enable WEP
Key Information
Enter the key # specified for use by the handsets.
Default Key
This will be 1 through 4.
Select either
Key Length
length specified for use at this location.
Scroll to the key option that corresponds to the
Key 1-4
that was entered above. Enter the encryption key as a
Key
sequence of hexadecimal characters. (Use the
access hexadecimal digits
This is used for proprietary WEP key rotation. Refer
Rotation Secret
to your custom document if this feature is supported in your
system.
SpectraLink 8020/8030 Wireless Telephone Configuration
or .
Shared Key
or .
Disable WEP
or , depending on the key
40-bit 128-bit
through
A F.
Default
and keys to
2 3
29