Spectralink 8020/8030 Wireless Telephone Configuration; The Admin Menu - Polycom SpectraLink 8020 Administration Manual

SpectraLink 8020/8030
Wireless Telephone Configuration

The Admin Menu

1725-36030-001_B.doc
Prior to configuring a SpectraLink 8020/8030 Wireless Telephone, it
must be associated with one and only one line on one of the
SpectraLink 8000 Telephony Gateways. Then it must be configured
per the instructions in this section. The following instructions assume
that the handset has been properly associated with a line on a
SpectraLink 8000 Telephony Gateway. See SpectraLink 8000 Telephony
Gateway: Administration Guide for additional information. While
handsets are being associated, the system will continue normal
operation.
Use the Wireless Device Planning Worksheets filled out by the network
or system administrator to be sure you are correctly assigning
telephone parameters.
The SpectraLink Handset Administration Tool is a software utility
that enables rapid configuration of handsets by utilizing the USB port
on the Dual Charger. See the Handset Administration Tool document
for specific instructions. Please see your service representative or
contact Polycom customer service for more information about this
time-saving tool.
The Admin menu contains configuration options that are stored
locally (on each handset). Every handset is independently configured
and if the default settings are not desired, the Admin menu options
must be set in each handset requiring different settings.
Opening the Admin menu
1. With the handset powered off, press and hold the
While holding the
2. When the Admin menu appears, release the
key, press and release the
START
2
key.
START
key.
END
key.
START
19