Polycom SpectraLink 8020 Administration Manual page 47

1725-36030-001_B.doc
In detail mode the display would appear as follows. The left/right
arrow keys will move between AP indices.
i : b b b b b b
e e e e e e e e e e e
r r r r r r r r r r r r r + x x x x
m m m G : g g g g
A n y
Where:
• i – index of selected AP (value will be from 0 to 3 inclusive)
• bbbbbb – the last three octets of the BSSID for a discovered AP
• sn – signal strength in –dBm
ch – channel
•
• bcn – beacon interval
• eeeeeeeeeee – SSID (up to first 11 characters)
DGHI – standards supported
•
• rrrrrrrr – rates supported. Basic rates will have a "b" following the
rate
• + – more rates are supported than those displayed
• xxxx – WMM or UPSD if those QoS methods are supported
• mmm – security mode
G:gggg – group key security
•
• P:pppp – pairwise key security
• Any/MyID – softkey to toggle between "single SSID" and "any
SSID" modes
• Detl/Smry – softkey to toggle between the multiple AP display
(summary), and the single AP display (detail)
Numbers racing across the handset display indicate AP information is
being obtained. A
Waiting
configured properly and the handset cannot find any APs.
s n c h b c n
D G H I
P : p p p p
S m r y
message indicates the system is not
Diagnostic Tools
47