Startup Sequence - Polycom SpectraLink 8020 Administration Manual

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SRP

Startup Sequence

Icon The icon(s) shown in bold turns off when:
123456789 The handset has located and authenticated and associated with at least one AP, and is
proceeding to bring up higher-layer networking functions.
12345678 The handset is either configured for Static IP, or if configured for DHCP the DHCP
discovery process has started.
1234567 If DHCP is configured, a DHCP response was received which contains a good DNS
server configuration.
123456 Note: Only valid on non-SRP protocol. Indicates one of the following:
Static IP configuration, or
SVP Server address found in DHCP response, or
SVP Server address found via DNS lookup.
12345 All networking functions are complete (notably, DHCP), and the handset is proceeding
with establishing the SRP link to the SpectraLink 8000 Telephony Gateway.
1234 The SRP link is established, all network stack initialization is complete, proceeding with
application-specific initialization.
123 The link between the handset and the SpectraLink 8000 Telephony Gateway is
established.
(no icons) Initialization is complete. The handset is in standby mode ready to receive and place
calls.
EXT. XXX
16
The handset goes through an initialization sequence at startup. The
line icons through
1 9
through this sequence. This is usually very rapid. If there is difficulty
at any step that prevents initialization from continuing, an error
message will display and the related icon(s) will stay on. Please see
the Handset Status Messages table at the back of this document for
instructions on how to handle error messages that occur during
initialization.
display and count down as the handset steps
1725-36030-001_B.doc