Polycom SpectraLink 8020 Administration Manual page 26
Spectralink 8000 telephony gateway
and spectralink radio protocol (srp)
Hide thumbs
Also See for SpectraLink 8020:
- Administration manual (145 pages) ,
- Administrator's manual (137 pages) ,
- User manual (71 pages)
Table of Contents
Advertisement
SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SRP
26
for this key press are 1-9, 0, *, #, or ^. The carat represents the volume
up and down buttons. This number must be programmed in every
handset. This setting cannot be modified by the user. This feature is
not available in a handset where the user has disabled
.
Config menu
Password Enable/Disable/Change
The password option controls access to the Admin menu. It is enabled
by default with the password 123456. The
a toggle between
Enabled
current state. Press
NavOK
modify the password requirement, the default or previously set
password must be entered to verify the change.
appear only if the password is enabled. The password is disabled by
default. The password must be set in each handset for which
controlled access is desired.
Speakerphone Enable/Disable
The speakerphone may be disabled when quiet handset operation is
required. The current speakerphone setting is shown on the info line.
Press
to toggle to the alternate setting.
NavOK
The speakerphone option must be programmed in the SpectraLink
8000 Telephony Gateway for it to function as an off-hook softkey
option. See SpectraLink 8000 Telephony Gateway: Administration
Guide for more information.
If the speakerphone is disabled in the Admin menu, the
softkey will not appear during standby. However, if it has been
programmed in the SpectraLink 8000 Telephony Gateway, the
softkey will appear during active mode but it will be non-
Spkr
functional.
Location Service
Location service may be used to enable or disable the Ekahau Real-
Time Location System (RTLS), select a transmit interval, or enter a
static IP address for the Ekahau Positioning Engine (EPE). Location
services capability is provided by the EPE 4.0 using Ekahau Location
Protocol (ELP). See Ekahau's user documentation for more
information.
Password
and
. The info line will display the
Disabled
to change the password protection state. To
-
in the
Pre
dial
option operates as
will
Change Password
Spkr
1725-36030-001_B.doc
Advertisement
Table of Contents
