Tasks To Be Performed When Needed; Print Out Of The Nozzle Check Pattern (Checking On The Print Heads) - Brother GTX-4 Instruction Manual

7-2. Tasks to be performed when needed

7-2-1. Print out of the nozzle check pattern (checking on the print heads)

By printing out a nozzle check pattern, you can check on the printing quality.
It is recommended to always perform this procedure to verify the output.
(1) Put the platen 14X16 in place, and position its level at "A".
<TIPS>

For details, refer to "6-4-1. Replacing the currently used platen with another one >>P.143" and "6-4-2. Platen height
adjustment >>P.146".
(2) As illustrated below, put the A4-size or letter-size white paper on the platen in alignment with the right-hand corner
of the platen at its front edge.
When the paper is loosely fitted, fix its edge with a tape or the like.
A T-shirt can also be used instead.
<TIPS>

When printing out a nozzle check pattern on the white side, print it on a pretreated black or dark color textile or black paper,
or a transparent sheet (such as OHP sheet).
Platen
(3) From the menu, select [Test Print] > [Nozzle Check CMYK], and press
Then, printing will begin.
After printing on the color side is completed, remove the printed paper and replace it with a paper for printing on the
(4)
white side.
From the menu, select [Test Print] > [Nozzle Check White], and press
(5)
Then, printing will begin.
Precautions to keep good printing quality/use printer over the long term
Paper
198
.
.
X0043