Brother GTX-4 Instruction Manual page 154

(5) The T-shirt should be placed on the T-shirt tray, trying not to draw the excessive parts like sleeves and hems into
the printer.
T-shirt
T-shirt tray
On the operation panel, press
(6)
Try moving the platen, and check on the gap between the T-shirt surface and the obstacle sensor over the entire print area.
<TIPS>

If this gap is too wide, adjust it by rotating the platen height adjustment lever.

Adjust the height so that it is lowered by one step from the limit height detected by the obstacle sensor, and check that the
platen is not detected by the sensor.

If the platen's height is too high, a print medium will strike against the print head during the printing process, which in turn
results in ink stains or malfunction.

If the 16X21 platen is mounted, manually slide it backward until it returns to the original position, then move the platen
toward the rear of the printer.
(7) On the operation panel, press
<TIPS>

Repeat the height adjustment until the platen will be positioned at a proper height.

After your desired height is determined, start the printing operation. For details, refer to "6-7. Executing a printing job
>>P.167".
T-shirt
T-shirt tray
, and move the platen toward the rear of the printer.
, and move the platen toward the front of the printer.
154
Basic printing procedures
X0112
X0113