Brother GTX-4 Instruction Manual page 171

Ink fixation by means of heat press
(1) Place the silicone foam, T-shirt and peel-off sheet in position under the heat press first, and fixate the pretreatment
properly.
<TIPS>

For the guidelines on fixation conditions of ink, please refer to "6-9. Fixation of ink >>P.170".

For details, refer to the instruction manual of your heat press.

There is a tendency to bring the print result to an almost matte finish if a silicone-coated paper is used as a peel-off sheet or
to an almost bright finish if a fluororesin sheet is used as the same at the ink fixation stage. Selectively use either of them
according to your desired finish.
Ink fixation by means of conveyor-type oven
(1) Fixate inks onto a T-shirt by means of the conveyor-type oven.
<TIPS>

For the guidelines on fixation conditions of ink, please refer to "6-9. Fixation of ink >>P.170".

For the conveyor-type oven, identify the oven's internal temperature, and check up on actual ink fixation result.

For details, refer to the instruction manual of your conveyor-type oven.
T-shirt
out
Heat press
Silicone foam
Peel-off sheet
T-shirt
Conveyor-type oven
171
Basic printing procedures
X0115
in
X0116