Tasks To Be Performed Before Starting Print Operation; Confirmation And Disposal Of Waste Ink - Brother GTX-4 Instruction Manual

6-2. Tasks to be performed before starting print operation

6-2-1. Confirmation and disposal of waste ink

Check the amount of waste ink in the waste ink tank, and if the tank is filled with the waste ink up to its one-half or higher
level, discard the ink.
(1) Check on the waste ink tank, and discard the waste ink.
In an area under the other end of the waste ink tube (when removed) from the waste ink tank, place a receiving tray or the like so
that the waste ink spilled from the tube will not be discharged onto the floor, etc.
<NOTE>

Dispose of the waste ink properly as water-based waste fluid in accordance with applicable laws and ordinances.
Waste ink tank
(2) Return the waste ink tank to its original state, and insert the waste ink tube into the tank.
<NOTE>

Be sure to ascertain that a flow path for the waste ink is provided properly and the waste ink tube is not bent or broken.

The waste ink tube should be inserted into the waste ink tank so that the immersed length of the tube will be 1.6 to 2 in. (4
to 5 cm).
Waste ink tank
Receiving tray
Waste ink tube
125
Basic printing procedures
X0045
X0046