Prepare For Drive Start-Up - Allen-Bradley PowerFlex 70 User Manual

Start Up
This chapter describes how you start up the PowerFlex 70 Drive. Refer
to Appendix B
Interface Modules.
For information on...

Prepare For Drive Start-Up

Status Indicators
Start-Up Routines
ATTENTION: Power must be applied to the drive to perform the
following start-up procedures. Some of the voltages present are at
!
incoming line potential. To avoid electric shock hazard or damage to
equipment, only qualified service personnel should perform the
following procedure. Thoroughly read and understand the procedure
before beginning. If an event does not occur while performing this
procedure, Do Not Proceed. Remove All Power including user
supplied control voltages. User supplied voltages may exist even when
main AC power is not applied to the drive. Correct the malfunction
before continuing.
Prepare For Drive Start-Up
Before Applying Power to the Drive
❏
1. Confirm that all inputs are connected to the correct terminals and are
secure.
❏
2. Verify that AC line power at the disconnect device is within the rated
value of the drive.
❏
3. Verify that any control power is 24 volts.
The remainder of this procedure requires that a HIM be installed. If an
operator interface is not available, remote devices should be used to start
up the drive.
for a brief description of the LED and LCD Human
See page
2-1
2-2
2-3
Chapter
For information on...
Running S.M.A.R.T. Start
Running an Assisted Start Up 2-4
2
See page
2-4