Allen-Bradley PowerFlex 70 User Manual page 72

3-36 Programming and Parameters
No. Parameter Name and Description
380 [Digital Out1 Sel]
[Digital Out2 Sel]
384
Selects the drive status that will energize
a (CRx) output relay.
(1)
Contacts shown on page
drive powered state with condition not
present. For functions such as "Fault"
and "Alarm" the normal relay state is
energized and N.O. / N.C. contact
wiring may have to be reversed.
381 [Dig Out1 Level]
[Dig Out2 Level]
385
Sets the relay activation level for options
10 – 15 in [Digital Outx Sel]. Units are
assumed to match the above selection
(i.e. "At Freq" = Hz, "At Torque" = Amps).
382 [Dig Out1 OnTime]
[Dig Out2 OnTime]
386
Sets the "ON Delay" time for the digital
outputs. This is the time between the
occurrence of a condition and activation
of the relay.
383 [Dig Out1 OffTime]
[Dig Out2 OffTime]
387
Sets the "OFF Delay" time for the digital
outputs. This is the time between the
disappearance of a condition and
de-activation of the relay.
Values
Default:
Options:
1-14 are in
Default:
Min/Max:
Display:
Default:
Min/Max:
Display:
Default:
Min/Max:
Display:
1 "Fault"
4 "Run"
(1)
1 "Fault"
(1)
2 "Alarm"
3 "Ready"
4 "Run"
5 "Forward Run"
6 "Reverse Run"
7 "Auto Restart"
8 "Powerup Run"
9 "At Speed"
10 "At Freq"
11 "At Current"
12 "At Torque"
13 "At Temp"
14 "At Bus Volts"
15 "At PI Error"
16 "DC Braking"
17 "Curr Limit"
18 "Economize"
19 "Motor Overld"
20 "Power Loss"
21 "Input 1 Link"
22 "Input 2 Link"
23 "Input 3 Link"
24 "Input 4 Link"
25 "Input 5 Link"
26 "Input 6 Link"
0.0
0.0
0.0/819.2
0.1
0.0 Secs
0.0 Secs
0.0/600.0 Secs
0.1 Secs
0.0 Secs
0.0 Secs
0.0/600.0 Secs
0.1 Secs
381
385
382
386
383
002
001
003
004
218
012
137
157
147
053
048
184
380
380
380