Allen-Bradley PowerFlex 70 User Manual page 38

3-2 Programming and Parameters
– — ˜ ™
No. Parameter Name and Description
202 [Voltage Class]
Configures the drive current rating and
associates it with the selected voltage
(i.e. 400 or 480V). This parameter is
normally used when downloading
parameter sets.
216 [Dig In Status]
Status of the digital inputs.
Bit #
218 [Drive Temp]
Present operating temperature of the
drive power section.
No. Description
–
File – Lists the major parameter file category.
—
Group – Lists the parameter group within a file.
˜
No. – Parameter number.
™
Parameter Name and Description – Parameter name as it appears on an LCD HIM, with a
brief description of the parameter's function.
š
Values – Defines the various operating characteristics of the parameter. Three types exist.
ENUM Default:
Options:
Bit Bit #
Numeric Default:
Min/Max:
Display:
›
Related – Lists parameters (if any) that interact with the selected parameter.
x x x x x x x
15 14 13 12 11 10 9
Nibble 4 Nibble 3
= Stop drive before changing this parameter.
32
= 32 bit parameter.
Lists the value assigned at the factory. "Read Only" = no default.
Displays the programming selections available.
Lists the bit place holder and definition for each bit.
Lists the value assigned at the factory. "Read Only" = no default.
The range (lowest and highest setting) possible for the parameter.
Unit of measure and resolution as shown on the LCD HIM.
Important: When sending values through DPI ports, simply remove
the decimal point to arrive at the correct value (i.e. to send "5.00 Hz,"
use "500").
š
Values
Default:
Options:
x x x 0 0 0 0 0
8 7 6 5 4 3 2 1
Nibble 2 Nibble 1
Default:
Min/Max:
Display:
Based on Drive Cat.
No.
2 "Low Voltage"
3 "High Voltage"
0 1 =Input Present
0 =Input Not Present
0
x =Reserved
Read Only
0.0/100.0%
0.1%
›