Start-Up Routines - Allen-Bradley PowerFlex 70 User Manual

Start-Up Routines

The PowerFlex 70 is designed so that start up is simple and efficient. If
you have an LCD HIM, two start-up methods are provided, allowing the
user to select the desired level needed for the application.
• S.M.A.R.T. Start
This routine allows you to quickly set up the drive by programming
values for the most commonly used functions (see below).
• Assisted Start Up
This routine prompts you for information that is needed to start up a
drive for most applications, such as line and motor data, commonly
adjusted parameters and I/O.
Figure 2.2 Start Up Menu
Main Menu:
Start-Up
Input Voltage Motor Data and
Ramp Times
Configure for Enter Motor NP
Alternate Input Data, Stop Mode,
Voltage Accel/Decel
Ramp Times
If you do not have an LCD HIM, you must set parameters individually
using the LED HIM or other configuration tools, Refer to
parameters.
Important: Power must be applied to the drive when viewing or
changing parameters. Previous programming may affect the
drive status when power is applied.
Motor Tests Speed Limits
Optimize Torque Set Min/Max
and Speed and
Verify Direction Direction Control
Start Up
Speed Control Start/Stop/I/O
Configure Configure
Source, Value Control Method
and Scale for (2 Wire/3 Wire), I/O,
Speed References Digital Inputs/Outputs
and Analog Outputs
Chapter 3
2-3
Done /
Exit
for