Status Indicators - Allen-Bradley PowerFlex 70 User Manual

2-2 Start Up
Applying Power to the Drive
❏
4. Apply AC power and control voltages to the drive.
If any of the six digital inputs are configured to Stop – CF
(CF = Clear Fault) or Enable, verify that signals are present or the drive
will not start. Refer to
potential digital input conflicts.
If a fault code appears, refer to
If the STS LED is not flashing green at this point, refer to Status
Indicators and their indications below.
❏
5. Proceed to Start-Up Routines.

Status Indicators

Figure 2.1 Drive Status Indicators
# Name Color State
–
STS (Status) Green Flashing
Yellow
See
page
4-7
Red
See
page
4-3
—
PORT Refer to the
Communication
MOD
Adapter User Manual.
NET A
NET B
Alarm Descriptions on page 4-7
—
Description
Drive ready, but not running and no faults are present.
Steady Drive running, no faults are present.
Flashing, A type 2 alarm condition exists, the drive cannot be
Drive Stopped started. Check parameter 212 [Drive Alarm 2].
Flashing, An intermittent type 1 alarm condition is occurring.
Drive Running Check parameter 211 [Drive Alarm 1].
Steady, A continuous type 1 alarm condition exists.
Drive Running Check parameter 211 [Drive Alarm 1].
Flashing A fault has occurred.
Steady A non-resetable fault has occurred.
Status of DPI port internal communications (if present).
Status of communications module (when installed).
Status of network (if connected).
Status of secondary network (if connected).
Chapter 4.
for a list of
–