Clearing Alarms; Alarm Descriptions - Allen-Bradley PowerFlex 70 User Manual

Table 4.B Fault Cross Reference
(1)
No. Fault
2 Auxiliary Input
3 Power Loss
4 UnderVoltage
5 OverVoltage
7 Motor Overload
8 Heatsink OvrTemp
9 Trnsistr OvrTemp
12 HW OverCurrent
13 Ground Fault
24 Decel Inhibit
25 OverSpeed Limit
29 Analog In Loss
33 Auto Rstrt Tries
36 SW OverCurrent
(1)
Fault numbers not listed are reserved for future use.

Clearing Alarms

Alarms are automatically cleared when the condition that caused the
alarm is no longer present.

Alarm Descriptions

Table 4.C Alarm Descriptions and Actions
Alarm Description
➀
Analog in Loss An analog input is configured for "Alarm" on signal loss and signal loss has
occurred.
➁
Bipolar Conflict Parameter 190 [Direction Mode] is set to "Bipolar" or "Reverse Dis" and one or
more of the following digital input functions is configured:
"Fwd/Rev", "Run Fwd", "Run Rev", "Jog Fwd", or "Jog Rev".
➀
Decel Inhibit Drive is being inhibited from decelerating.
(1)
No. Fault
38 Phase U to Grnd
39 Phase V to Grnd
40 Phase W to Grnd
41 Phase UV Short
42 Phase UW Short
43 Phase VW Short
48 Params Defaulted
63 Shear Pin
64 Drive Overload
69 DB Resistance
70 Power Unit
71-76 Port 1-6 Adapter
77 IR Volts Range
Troubleshooting
(1)
No. Fault
78 FluxAmpsRef Rang
79 Excessive Load
80 AutoTune Aborted
81-86 Port 1-6 DPI Loss
100 Parameter Chksum
101 UserSet1 Chksum
102 UserSet2 Chksum
103 UserSet3 Chksum
104 Pwr Brd Chksum1
105 Pwr Brd Chksum2
106 Incompat MCB-PB
107 Replaced MCB-PB
108 Anlg Cal Chksum
4-7