Getting Started With The Tds1000B And Tds2000B Series Oscilloscopes - Tektronix TDS1000B Series Operator's Manual

2
Getting Started with the TDS1000B and
TDS2000B Series Oscilloscopes
This module describes the TDS1000B and TDS2000B
series of digital storage oscilloscopes. You will learn how to
functionally check these oscilloscopes for general operation,
and verify the probes for correct calibration. You will also
learn how to power and use the Training 1 signal board that
will be used in operational procedures later in this manual.
You will then learn about the basic features, specifications,
and primary controls of a TDS1000B/TDS2000B
oscilloscope.
The two final sections of this module, covering Primary
Controls and Enhanced Features, are also covered in your
Operator Manual. Except for the probe calibration procedure
in this module, all hands on training procedures are in
Modules 3 to 6 in this manual.
TDS1000B and TDS2000B Series Oscilloscopes – Operator Training Kit 2-1