Tektronix TDS1000B Series Operator's Manual page 265

5. Read the period, frequency, and delta amplitude
measurements for the waveform in the side-screen
menu box Δt.
You will see a waveform similar to that shown in Figure
6.10. The measurements displayed in Δt are the period,
frequency, and delta amplitude measurements for the 5 kHz
SINE signal from pin 10 on the Training 1 signal board. The
actual reading may vary from the stated 5 kHz frequency.
However, this Delta reading for frequency should be very
close to the trigger frequency reading at the bottom of the
display.
Figure 6.10: Period and frequency measurements for a 5 kHz
TDS1000B and TDS2000B Series Oscilloscopes – Operator Training Kit
Using Menu Function Controls
sine wave
6
6-29