Autorange Menu Function Controls; Automatic Adjustment Of Oscilloscope Settings - Tektronix TDS1000B Series Operator's Manual

Digital storage oscilloscopes
Hide thumbs Also See for TDS1000B Series:
Table of Contents

Advertisement

AUTORANGE Menu Function Controls

You use the AUTORANGE Menu Function Controls to have
the oscilloscope automatically track and adjust settings as a
signal changes.

Automatic Adjustment of Oscilloscope Settings

In the following procedure, you watch the AUTORANGE
function automatically adjust settings as you move probe
from one point to another.
To watch the AUTORANGE function in action, follow these
steps:
1. Connect the CH1 probe tip to the CLK 20 MHz signal on
pin 2 and CH1 ground lead to GND on pin 1of the
Training 1 signal board. Make sure no other channel is
connected to a signal.
2. On the Training 1 signal board, push the POWER button
until the Digital PWR LED is on.
3. On the top of the front panel, push the DEFAULT
SETUP menu button.
4. On the top of the front panel, push the AUTOSET
button.
5. On the top of the front panel, push the AUTORANGE
button.
TDS1000B and TDS2000B Series Oscilloscopes – Operator Training Kit
Using Menu Function Controls
6
6-55

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TDS1000B Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Tds2000b series

Table of Contents