Cli: Tftp Download From A Server To Flash - HP ProCurve 6400cl Series Management And Configuration Manual

N o t e
A "progress" bar indicates the progress of the download. When the entire
software file has been received, all activity on the switch halts and you
will see Validating and writing system software to FLASH...
7. After the primary flash memory has been updated with the new software,
you must reboot the switch to implement the newly downloaded software.
Return to the Main Menu and press
see this prompt:
Continue reboot of system?
Press the space bar once to change No to Yes, then press
the reboot.
When you use the menu interface to download a switch software, the new
image is always stored in primary flash. Also, using the Reboot Switch
command in the Main Menu always reboots the switch from primary flash.
Rebooting the switch from the CLI gives you more options. See "Reboot­
ing the Switch" on page 6-17.
8. After you reboot the switch, confirm that the software downloaded cor­
rectly:
a. From the Main Menu, select 1. Status and Counters, and from the Status
and Counters menu, select 1. General System Information
b. Check the Firmware revision line.

CLI: TFTP Download from a Server to Flash

Syntax: copy tftp flash <ip-address> <remote-file> [< primary | secondary >]
This command automatically downloads a switch software
file to primary or secondary flash. Note that if you do not
specify the flash destination, the Xmodem download defaults
to primary flash.
For example, to download a switch software file named E0800.swi from a
TFTP server with the IP address of 10.28.227.103 to primary flash:
Downloading Switch Software
(for Reboot Switch). You will then
[6]
: No
File Transfers
to begin
[Enter]
A-5