Viewing And Configuring Cdp On The Switch - HP ProCurve 6400cl Series Management And Configuration Manual

Figure 14-23 (page 14-57) illustrates how multiple CDP Neighbors can appear
on a single port. In this case, switch "A" has three CDP Neighbors on port 1
because the intervening devices are not CDP-capable and simply forward CDP
Neighbors data out all ports (except the port on which the data was received).
Default Configuration. In the factory-default configuration, CDP is
enabled and running on all ports. In this case, the holdtime is 180 seconds and
the timer (CDP Transmit Interval) is 60 seconds.

Viewing and Configuring CDP on the Switch

On a Series 5300xl switch you can:
■ View the switch's current global and per-port CDP configuration
List the current contents of the switch's CDP Neighbors Table (that
■
is, view a listing of the CDP devices of which the switch is aware)
Enable or disable CDP (Default: Enabled)
■
■ Specify the hold time (CDP packet time-to-live) for CDP data deliv­
ered to neighboring CDP devices. For example, in CDP switch "A" you
can specify the hold time for switch "A" entries in the CDP Neighbor
Tables of other CDP devices. (Default: 180 seconds)
■ Specify the transmission interval for CDP packets. (Default: 60
seconds)
CLI: CDP Commands
CDP Commands
show CDP
show CDP neighbors
cdp clear
[no] cdp run
[no] cdp enable
cdp holdtime
cdp timer
Configuring for Network Management Applications
Page
14-60
14-60
14-62
14-62
14-63
14-64
14-64
CDP on the Series 5300xl Switches
14-59