HP ProCurve 6400cl Series Management And Configuration Manual page 173

Note: The Menu interface lists only the highest priority SNTP server, even if others are configured. To view all SNTP servers configured
on the switch, use the CLI show management command. Refer to "SNTP Unicast Time Polling with Multiple SNTP Servers" on page
9-24.
Figure 9-3. SNTP Configuration Fields for SNTP Configured with Unicast Mode
[>]
i. Press to move the cursor to the
ii. Enter the IP address of the SNTP server you want the switch to
use for time synchronization.
Note: This step replaces any previously configured server IP
address. If you will be using backup SNTP servers (requires use
of the CLI), then see "SNTP Unicast Time Polling with Multiple
SNTP Servers" on page 9-24.
[v]
iii. Press to move the cursor to the
value that matches the SNTP server version running on the device
you specified in the preceding step (step ii). If you are unsure
which version to use, HP recommends leaving this value at the
default setting of
whether any change is necessary.
Note: Using the menu to enter the IP address for an SNTP server
when the switch already has one or more SNTP servers config­
ured causes the switch to delete the primary SNTP server from
the server list and to select a new primary SNTP server from the
IP address(es) in the updated list. For more on this topic, see
"SNTP Unicast Time Polling with Multiple SNTP Servers" on page
9-24.
[>]
iv. Press to move the cursor to the
6.
6. In the Poll Interval field, enter the time in seconds that you want for a Poll
Interval. (For Poll Interval operation, see table 9-1, "SNTP Parameters",
on page 9-5.)
7. Press to return to the Actions line, then
[Enter]
new time protocol configuration in both the startup-config and running­
config files.
SNTP: Viewing, Selecting, and Configuring
Server Address
Server Version
and testing SNTP operation to determine
3
Poll Interval
[S]
Time Protocols
field.
field. Enter the
field, then go to step
(for ) to enter the
Save
9-7