Default Port Operation - HP ProCurve 6400cl Series Management And Configuration Manual

Table 12-5. LACP Port Status Data
Status Name Meaning
Port Numb Shows the physical port number for each port configured for LACP operation (C1, C2, C3 ... ). Unlisted port
numbers indicate that the missing ports are assigned to a static Trunk group, an FEC trunk group, or are
not configured for any trunking.
LACP Enabled Active: The port automatically sends LACP protocol packets.
Passive: The port does not automatically send LACP protocol packets, and responds only if it receives
LACP protocol packets from the opposite device.
A link having either two active LACP ports or one active port and one passive port can perform dynamic
LACP trunking. A link having two passive LACP ports will not perform LACP trunking because both ports
are waiting for an LACP protocol packet from the opposite device.
Note: In the default switch configuration, all ports are configured for passive LACP operation.
Trunk Group TrkX: This port has been manually configured into a static LACP trunk.
Trunk Group Same as Port Number: The port is configured for LACP, but is not a member of a port trunk.
Port Status Up: The port has an active LACP link and is not blocked or in Standby mode.
Down: The port is enabled, but an LACP link is not established. This can indicate, for example, a port that
is not connected to the network or a speed mismatch between a pair of linked ports.
Disabled: The port cannot carry traffic.
Blocked: LACP, spanning tree or, on the 5300xl only, FEC has blocked the port. (The port is not in LACP
Standby mode.) This may be due to a (brief) trunk negotiation or a configuration error such as differing
port speeds on the same link or trying to connect the switch to more trunks than it can support. (See the
table on page 12-4.)
Standby: The port is configured for dynamic LACP trunking to another device, but the maximum number
of ports for the Dynamic trunk to that device has already been reached on either the switch or the other
device. This port will remain in reserve, or "standby" unless LACP detects that another, active link in the
trunk has become disabled, blocked, or down. In this case, LACP automatically assigns a Standby port,
if available, to replace the failed port.
LACP Partner Yes: LACP is enabled on both ends of the link.
No: LACP is enabled on the switch, but either LACP is not enabled or the link has not been detected on
the opposite device.
LACP Status Success: LACP is enabled on the port, detects and synchronizes with a device on the other end of the
link, and can move traffic across the link.
Failure: LACP is enabled on a port and detects a device on the other end of the link, but is not able to
synchronize with this device, and therefore not able to send LACP packets across the link. This can be
caused, for example, by an intervening device on the link (such as a hub), a bad hardware connection,
or if the LACP operation on the opposite device does not comply with the IEEE 802.3ad standard.

Default Port Operation

In the default configuration, all ports are configured for passive LACP. How-
ever, if LACP is not configured as Active on at least one end of a link, then the
port does not try to detect a trunk configuration and operates as a standard,
untrunked port. Table 12-5 lists the elements of per-port LACP operation. To
display this data for a switch, execute the following command in the CLI:
HPswitch> show lacp
Port Trunking
Trunk Group Operation Using LACP
12-21