Menu: Configuring Port and Static Trunk Monitoring
This procedure describes configuring the switch for monitoring when moni
toring is disabled. (If monitoring has already been enabled, the screens will
appear differently than shown in this procedure.)
1.
From the Console Main Menu, Select:
2. Switch Configuration...
3. Network Monitoring Port
Figure B-18. The Default Network Monitoring Configuration Screen
2.
In the Actions menu, press
3. If monitoring is currently disabled (the default) then enable it by pressing
the Space bar (or
4. Press the down arrow key to display a screen similar to the following and
move the cursor to the Monitoring Port parameter.
Monitoring and Analyzing Switch Operation
[E]
(for Edit).
) to select Yes.
[Y]
Interface Monitoring Features
Enable monitoring
by setting this
parameter to "Yes".
B-23