Trunk Group Operation Using Lacp - HP ProCurve 6400cl Series Management And Configuration Manual

Port Trunking

Trunk Group Operation Using LACP

N o t e
12-18
Trunk Group Operation Using LACP
The switch can automatically configure a dynamic LACP trunk group or you
can manually configure a static LACP trunk group.
LACP requires full-duplex (FDx) links of the same media type (10/100Base-T,
100FX, etc.) and the same speed, and enforces speed and duplex conformance
across a trunk group. For most installations, HP recommends that you leave
the port Mode settings at Auto (the default). LACP also operates with Auto-10,
Auto-100, and Auto-1000 (if negotiation selects FDx), and 10FDx, 100FDx, and
1000FDx settings.
LACP trunk status commands include:
Trunk Display Method
show lacp
CLI command
show trunk
CLI command
Port/Trunk Settings screen in menu interface
Thus, to display a listing of dynamic LACP trunk ports, you must use the show
lacp command.
In most cases, trunks configured for LACP on the switches covered by this
manual operate as described in table 12-4 on the next page.
Static LACP Trunk Dynamic LACP Trunk
Included in listing. Included in listing.
Included in listing. Not included.
Included in listing. Not included