Debug Types - HP ProCurve 6400cl Series Management And Configuration Manual

Troubleshooting
Debug and Syslog Messaging Operation
N o t e
C-36
Using the logging < dest-ip-addr > command to configure a Syslog server
address creates an exception to the above general operation. Refer to "Syslog
Operation" on page C-39.

Debug Types

This section describes the types of debug messages the switch can send to
configured debug destinations.
Syntax: [no] debug < debug-type >
acl
When a match occurs on an ACL "deny" Access Control
Entry (with log configured), the switch sends an ACL
message to the configured debug destination(s). For more
on ACLs, refer to the chapter titled "Access Control Lists" in
the Advanced Traffic Management Guide for your switch.
(Default: Disabled)
all
Configures the switch to send all debug types to the config­
ured debug destination(s). (Default: Disabled)
event
Configures the switch to send Event Log messages to the
configured debug destination(s). Note: This has no effect
on event notification messages the switch routinely sends
to the Event Log itself. Also, this debug type is automatically
enabled in these cases:
• If there is currently no Syslog server address configured
and you use logging < ip-addr > to configure an address.
• If there is currently at least one Syslog server address
configured and the switch is rebooted or reset.
ip
Enables all IP-OSPF message types for the configured des­
tinations.
lldp
Enables all LLDP message types for the configured destina­
tions.