Copying Event Log Output To A Destination Device - HP ProCurve 6400cl Series Management And Configuration Manual

At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-9. Example of Sending Event Log Content to a File on an Attached PC
Copying Diagnostic Data to a Remote Host, PC, or UNIX Workstation

Copying Event Log Output to a Destination Device

Syntax: copy event-log tftp < ip-address > < filepath_filename >
copy event-log xmodem
These commands use TFTP or Xmodem to copy the Event Log
content to a PC or UNIX workstation on the network.
For example, to copy the event log to a PC connected to the switch:
Copying Crash Data Content to a Destination Device
This command uses TFTP or Xmodem to copy the Crash Data content to a PC
or UNIX workstation on the network. You can copy individual slot information
or the master switch information. If you do not specify either, the command
defaults to the master data.
Syntax: copy crash-data [<slot-id | master>] xmodem
copy crash-data [<slot-id | master>] tftp <ip-address> <filename>
where: slot-id = a - h, and retrieves the crash log or crash data from
master
These commands use TFTP or Xmodem to copy the Event Log
content to a PC or UNIX workstation on the network.
For example, to copy the switch's crash data to a file in a PC:
the processor on the module in the specified slot.
Retrieves crash log or crash data from the switch's
chassis processor.
File Transfers
A-25