HP ProCurve 6400cl Series Management And Configuration Manual page 339

For example, if port 3 belongs to a subnetted VLAN that includes a secondary
IP address of 10.10.10.100 and you wanted port 3 to use this secondary address
in LLDP advertisements, you would need to execute the following command:
HPswitch(config)# lldp config 3 ipAddrEnable 10.10.10.100
Optional Data. You can configure an individual port or group of ports to
exclude one or more of these data types from outbound LLDP advertisements.
Note that optional data types, when enabled, are populated with data internal
to the switch; that is, you cannot use LLDP commands to configure their actual
content.
■ Port Description (TLV)
System Name (TLV)
■
■ System Description (TLV)
■ System Capabilities (TLV)
• System Capabilities Supported (TLV subelement)
• System Capabilities Enabled (TLV subelement)
Syntax [ no ] lldp config < port-list > basicTlvEnable <
port_descr
For outbound LLDP advertisements, includes an alphanu­
meric string describing the port.
system_name
For outbound LLDP advertisements, includes the system's
assigned name.
system_descr
For outbound LLDP advertisements, includes an alphanu­
meric string describing the full name and version identi­
fication for the system's hardware type, software version,
and networking application.
system_cap
For outbound advertisements, includes a bitmask of
system capabilities (device functions) that are supported.
Also includes information on whether the capabilities are
enabled.
For example, if you wanted to exclude the system name from the outbound
LLDP advertisements for all ports on a 3400cl-24G switch, you would use this
command:
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
TLV-Type >
14-43