Displaying Advertisement Data - HP ProCurve 6400cl Series Management And Configuration Manual

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
14-44
HPswitch(config)# no lldp config 1-24 basicTlvEnable
system_name
If you later decided to reinstate the system name on ports 1-5, you would use
this command:
HPswitch(config)# lldp config 1-5 basicTlvEnable
system_name

Displaying Advertisement Data

Command
show lldp info local-device
show lldp info remote-device
show lldp info stats
Displaying Switch Information Available for Outbound
Advertisements
These commands display the current switch information that will be used to
populate outbound LLDP advertisements.
Syntax show lldp info local-device [ port-list ]
Without the [ port-list ] option, this command displays the global
switch information and the per-port information currently
available for populating outbound LLDP advertisements.
With the [ port-list ] option, this command displays only the
following port-specific information that is currently available
for outbound LLDP advertisements on the specified ports:
• PortType
• PortId
• PortDesc
Note: This command displays the information available on
the switch. Use the lldp config < port-list > command to change
the selection of information that is included in actual out-
bound advertisements. In the default LLDP configuration, all
information displayed by this command is transmitted in
outbound advertisements.
Page
below
14-46
14-49