HP ProCurve 6400cl Series Management And Configuration Manual page 332

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
14-36
For example, show lldp config produces the following display when the switch
is in the default LLDP configuration:
Figure 14-10. Example of Viewing the General LLDP Configuration
Displaying Port Configuration Details. This command displays the port-
specific configuration, including .
Syntax show lldp config < port-list >
Displays the LLDP port-specific configuration for all ports in
< port-list >, including which optional TLVs and any non-default
IP address that are included in the port's outbound advertise­
ments. For information on the notification setting, refer to
"Configuring SNMP Notification Support" on page 14-40. For
information on the other configurable settings displayed by
this command, refer to "Configuring Per-Port LLDP Transmit
and Receive Modes" on page 14-41.
Note: This value corresponds
to the lldp refresh-interval
command (page 14-38).