Fitting The Hose Bracket; Drainage Canister Hook; Compressed Air Distributor/Socket Strip; Storage - Dräger Babytherm 8004 Instructions For Use Manual

Fitting the hose bracket

Insert the hose bracket into the hole in the left side of the
●
head panel and tighten with knurled screw.

Drainage canister hook

1 Insert hook horizontally into hole in the Babytherm casing.
2 Pivot hook downwards.

Compressed air distributor/socket strip

● Secure the compressed air distributor to the standard rail.
Secure the socket strip to the standard rail.
●

Storage

Units with height-adjustable column:
– One or two swivel cabinets each with 2 swivel compart-
ments and 1 swivel tray, optional.
Units without height adjustment:
– Two open compartments in the column
– One swivel cabinet with two swivel compartments and one
swivel tray, optional.
For clearly organised storage of required equipment and
●
accessories.

In-hospital transport

Monitor the patient's core temperature.
●
If optional height adjustment is fitted, lower the unit to its
●
lowest position.
● Swivel the swivel cabinets inwards.
Swivel the swivel tray inwards.
●
Remove X-ray cartridge from X-ray tray (see page 49).
●
Accessories projecting beyond either side of the unit must
●
be removed or folded in.
Switch off heating systems and disconnect the mains plug.
●
Fit optional bed canopy to protect patient from draughts.
●
Immediately after transport:
Plug in the mains plug and switch on the heating systems.
●
1
2
2
Preparation
17