Table of Contents
Advertisement
Processing
Lettermail on
the DM230L/
DM330L
System without
the optional
weight platform
continued...
SV61891 Rev. A
DM230L, DM330L, DM350L Operating Guide
3. Push the envelope to the rear (A)
so its top edge is up against the
back wall of the system.
4. Slide the envelope to the right (B)
until the system grasps it. The
system prints the postage and
ejects the envelope.
If you want to seal the envelope:
1. Hold the envelope ADDRESS SIDE UP.
2. Pull the flap slightly away from the envelope.
3. Slide just the flap under the blue edge of the feed deck as shown.
A brush below the deck wets the flap.
4. Slide the envelope to the right until the system takes hold of it.
The system prints the postage and ejects the piece.
5. To complete sealing, compress the envelope stack.
See Chapter 6 for instructions on refilling and maintaining the
moistener.
DM330L shown above.
3-5
Advertisement
Table of Contents
