6 • Maintenance
Filling the
Moistener
The DM230L/
DM330L System
6-2
The procedures for filling the moistener are different for the DM230L/
DM330L and the DM350L systems. Refer to the appropriate procedure in
this section.
1. Check the moistener tank to see
how much sealing solution is left.
2. Add enough E-Z Seal
sealant level up to the bottom of
the fill hole. We recommend E-Z
Seal
Sealing Solution because it
®
helps keep your moistener clean
and improves sealing efficiency.
3. If the tank was empty, allow 30 minutes for the moistener brush and
wick to get completely wet.
CAUTION! Do not overfill the moistener tank.
to bring the
®
Check Level Here
Fill Here
SV61891 Rev. A