Setting The Default Refill Amount; Password Protecting The Adding Postage Process; Removing Funds And Purging Ink From Your System - Pitney Bowes DM230L Operator's Manual

Setting the
Default Refill
Amount
Password
Protecting
the Adding
Postage
Process
Removing
Funds and
Purging Ink
from Your
System
SV61891 Rev. A
DM230L, DM330L, DM350L Operating Guide
1. Press the Options key.
2. Select Setup Menu, then Basic Settings.
3. Select Refill Setup.
4. Select Default Refill Amount.
5. Key in the postage refill amount you usually add. This is the normal
or "default" value. Do not enter a value more than $99,999.
6. Press Enter. The display shows the value you entered.
If your system was set up to ask for a supervisor password you can also
have it request a password when you add postage:
1. Press the Options key.
2. Select Setup Menu, then Basic Settings.
3. Select Refill Setup.
4. Select Password Protect Refill.
5. Select Enable Password Protect Refill.
If the refill operation is already password protected and you would like
to disable it, select Disable Password Protect Refill.
If you are moving your system and you need to transfer funds from your
control centre back to your Postage By Phone
here.
NOTE: Use this option only if a Postage By Phone
to do so. Otherwise, it will not work.
1. Press the Options key.
2. Select Setup Menu, then Advanced Functions.
3. Select Remove Funds/Purge Ink.
4. Follow the prompts in the display.
®
account, follow the steps
representative instructs you
®
4-15