To Configure The Orp Measurement Board - Emerson Rosemount 1056 Instruction Manual

Instruction Manual
LIQ-MAN-1056
A detailed flow diagram for ORP programming is
provided at the end of Sec. 6 to guide you through
all basic programming and configuration functions.

To configure the ORP measurement board:

1. Press MENU
2. Scroll down to Program. Press ENTER.
3. Scroll down to Measurement. Press ENTER.
4. Select Sensor 1 or Sensor 2 corresponding to
ORP. Press ENTER.
The adjacent screen format will appear (factory defaults
are shown). To program any displayed function, scroll
to the desired item and press ENTER.
The following sub-sections provide you with the initial display screen that appears for each configuration function.
Use the flow diagram for ORP programming at the end of Sec. 6 and the Model 1056 live screen prompts for
each function to complete configuration and programming.
6.3.2 Measurement
The display screen for selecting the measurement is
shown. The default value is displayed in bold type.
Refer to the pH/ORP Programming flow diagram to
complete this function.
6.3.3 Preamp
The display screen for identifying the Preamp location is
shown. The default value is displayed in bold type.
Refer to the pH/ORP Programming flow diagram to
complete this function.
6.3.4 Filter
The display screen for entering the input filter value in
seconds is shown. The default value is displayed in
bold type. Refer to the pH/ORP Programming flow diagram
to complete this function.
6.3.5 Reference Impedence
The display screen for Selecting Low or high Reference
impedance is shown. The default value is displayed in
bold type. Refer to the pH/ORP Programming flow diagram
to complete this function.
46
Section 6.0: Programming the Measurements
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Configure
Measure:
Preamp: Analyzer
Flter: 4 sec
Reference Z: Low
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Measurement
pH
ORP
Redox
Ammonia
Fluoride
Custom ISE
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Preamp
Analyzer
Sensor/JBox
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Input filter
04 sec
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Reference Z
Low
High
April 2017
pH