Temp Comp - Emerson Rosemount 1056 Instruction Manual

Instruction Manual
LIQ-MAN-1056
6.5.3 Measure
The display screen for selecting the measurement is
shown. The default value is displayed in bold type.
Refer to the toroidal conductivity Programming flow diagram
to complete this function.
6.5.4 Range
The display screen for Selecting Auto-ranging or a
specific range is shown. The default value is displayed
in bold type. Note: Ranges are shown as conductance,
not conductivity. Refer to the toroidal conductivity
Programming flow diagram to complete this function.
6.5.5 Cell Constant
The display screen for entering a cell Constant for the
sensor is shown. The default value is displayed in bold
type. Refer to the toroidal conductivity Programming
flow diagram to complete this function.

6.5.6 Temp Comp

The display screen
Compensation as Slope, Neutral Salt, or Raw is shown.
The default value is displayed in bold type. Refer to the
toroidal conductivity Programming flow diagram to com-
plete this function.
for Selecting Temperature
Section 6.0: Programming the Measurements
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Measurement
Conductivity
Resistivity
TDS
Salinity
NaOH (0-12%)
HCl (0-15%)
Low H2SO4
High H2SO4
NaCl (0-20%)
Custom Curve
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Range
Auto
2000 mS
50 mS
2 mS
200µS
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Cell Constant
3.00000 /cm
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
SN Temp Comp
Slope
Neutral Salt
Raw
April 2017
51