Procedure: Configure Outputs; Procedure: Assigning Measurements The Low And High Current Outputs; Procedure: Ranging The Current Outputs - Emerson Rosemount 1056 Instruction Manual

Instruction Manual
LIQ-MAN-1056

5.4.3 Procedure: Configure Outputs

Under the Program/Outputs menu, the adjacent screen
will appear to allow configuration of the outputs. Follow
the menu screens in Fig. 5-2 to configure the outputs.
5.4.4 Procedure: Assigning Measurements the Low
and High Current Outputs
The adjacent screen will appear when entering the
Assign function under Program/Output/Configure.
These screens allow you to assign a measurement,
process value, or temperature input to each output.
Follow the menu screens in Fig. 5-2 to assign
measurements to the outputs.

5.4.5 Procedure: Ranging the Current Outputs

The adjacent screen
Program/Output/Range. Enter a value for 4mA and
20mA (or 0mA and 20mA) for each output. Follow the
menu screens in Fig. 5-2 to assign values to the out-
puts.
will appear under
Figure 5-2. Configuring and Ranging the Current Outputs
Section 5.0: Programming the Analyzer - Basics
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
OutputM Configure
Assign: S1 Meas
Range: 4-20mA
Scale: Linear
Dampening:
Fault Mode: Fixed
Fault Value: 21.00mA
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
OutputM Assign
S1 Measurement
S1 Temperature
S2 Measurement
S2 Temperature
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
Output Range
OM SN 4mA:
OM SN 20mA: 20.00µS/cm
OM SN 4mA:
OM SN 20mA: 14.00pH
April 2017
0sec
0.000µS/cm
00.00pH
35