Orp Measurement Programming - Emerson 1057 Instruction Manual

MODEL 1057
6.2.4 Solution Temperature Correction
The display screen for selecting the Solution
temperature correction algorithm is shown. The default
value is displayed in bold type. Refer to the pH/ORP
Programming flow diagram to complete this function.
6.2.5 Temperature Coefficient
The display screen for entering the custom solution tem-
perature coefficient is shown. The default value is dis-
played in bold type.
Programming flow diagram to complete this function.
6.2.6 Resolution
The display screen for selecting 0.01pH or 0.1pH for pH
display resolution is shown. The default value is displayed
in bold type. Refer to the pH/ORP Programming flow
diagram to complete this function.
6.2.7 Filter
The display screen for entering the input filter value in
seconds is shown. The default value is displayed in
bold type. Refer to the pH/ORP Programming flow diagram
to complete this function.
6.2.8 Reference Impedence
The display screen for selecting Low or High Reference
impedance is shown. The default value is displayed in
bold type. Refer to the pH/ORP Programming flow diagram
to complete this function.

6.3 ORP MEASUREMENT PROGRAMMING

6.3.1 Description
The section describes how to configure the Model 1057 analyzer for ORP measurements. The following programming
and configuration functions are covered:
TABLE 6-2. ORP Measurement Programming
Measure Sec. Menu function:
ORP
6.3.2 Measurement type:
6.3.3 Preamp location:
6.3.4 Filter:
6.3.5 Reference Z:
Refer to the pH/ORP
default
pH
Analyzer
4 sec
Low
PROGRAMMING THE MEASUREMENTS
S1: 1.234µS/cm 1.234ºC
S2: 12.34pH
S3: 12.34µS/cm 1.234ºC
SN Sol'n Temp Corr.
Off
Ultra Pure Water
High pH
Custom
S1: 1.234µS/cm 1.234ºC
S2: 12.34pH
S3: 12.34µS/cm 1.234ºC
SN Sol'n Temp Coeff.
- 0.032pH/ºC
S1: 1.234µS/cm 1.234ºC
S2: 12.34pH
S3: 12.34µS/cm 1.234ºC
SN Resolution
0.01pH
0.1pH
S1: 1.234µS/cm 1.234ºC
S2: 12.34pH
S3: 12.34µS/cm 1.234ºC
SN Input filter
04 sec
S1: 1.234µS/cm 1.234ºC
S2: 12.34pH
S3: 12.34µS/cm 1.234ºC
SN Reference Z
Low
High
Description
Select pH, ORP, Redox, Ammonia, Fluoride, Custom ISE
Identify preamp location
Override the default input filter, enter 0-999 seconds
Select low or high reference impedance
SECTION 6.0
1.234ºC
1.234ºC
1.234ºC
1.234ºC
1.234ºC
31