Instruction Manual
LIQ-MAN-1056
6.4.3 Measure
The display screen for selecting the measurement is
shown. The default value is displayed in bold type.
Refer to the contacting conductivity Programming flow
diagram to complete this function.
6.4.4 Range
The display screen for Selecting Auto-ranging or a specific
range is shown. The default value is displayed in bold
type. Note: Ranges are shown as conductance, not
conductivity. Refer to the contacting conductivity
Programming flow diagram to complete this function.
6.4.5 Cell Constant
The display screen for entering a cell Constant for the
sensor is shown. The default value is displayed in bold
type. Refer to the contacting conductivity Programming
flow diagram to complete this function.
6.4.6 RTD Offset
The display screen for Entering the RTD Offset for the
sensor is shown. The default value is displayed in bold
type. Refer to the contacting conductivity Programming
flow diagram to complete this function.
6.4.7 RTD Slope
The display screen for entering the RTD slope for the
sensor is shown. The default value is displayed in bold
type. Refer to the contacting conductivity Programming
flow diagram to complete this function.
6.4.8 Temp Comp
The display screen for Selecting Temperature
Compensation as Slope, Neutral Salt, Cation or Raw is
shown. The default value is displayed in bold type.
Refer to the contacting conductivity Programming flow
diagram to complete this function.
48
Section 6.0: Programming the Measurements
S1: 1.234µS/cm
25.0ºC
S2: 12.34pH
25.0ºC
SN Measurement
Conductivity
Resistivity
TDS
Salinity
NaOH (0-12%)
HCl (0-15%)
Low H2SO4
High H2SO4
NaCl (0-20%)
Custom Curve
S1: 1.234µS/cm
25.0ºC
S2: 12.34pH
25.0ºC
SN Range
Auto
50 µS
500 µS
2000 µS
20 mS
200 mS
600 mS
S1: 1.234µS/cm
25.0ºC
S2: 12.34pH
25.0ºC
SN Cell Constant
1.00000 /cm
S1: 1.234µS/cm
25.0ºC
S2: 12.34pH
25.0ºC
SN RTD Offset
0.00°C
S1: 1.234µS/cm
25.0ºC
S2: 12.34pH
25.0ºC
SN RTD Slope
2.00%/ºC
S1: 1.234µS/cm
25.0ºC
S2: 12.34pH
25.0ºC
SN Temp Comp
Slope
Neutral Salt
Cation
Raw
April 2017