Table 62 Mbs Block Write Tab Configuration Parameters - Honeywell HC900 Reference Manual

Properties Function
Write tab
It looks like this graphically.
Properties Function
Edit Input Pins
Revision 11
2/07
Parameter Index #
T able 62 describes the parameters and the value or selection.
H

Table 62 MBS Block Write tab configuration parameters

Parameter Index #
N/A
Input Pin
N/A
Use Register
N/A
Address
(hex)
N/A
Register
Data Type
HC900 Hybrid Control Designer Function Block Reference Guide
Parameter Description
You must then select
which bit to mask (0-15).
The output will be the
floating-point equivalent
(0.0 or 1.0) of the masked
bit.
Parameter Description
Input pin designation
Register Request
Register Address
Register data type
Function Blocks
MBS Modbus Slave Function Block
Value or Selection
Value or Selection
Register request assigned to
WR1,WR2,WR3, or WR4 pin
Click on the "Use Register" field
to assign a register to the Input
pin.
Type in the address of the Write
register (in Hex) on the slave
device
From the drop down menu,
select the Register Data Type
• Float
• Unsigned 32
• Signed 32
• Unsigned 16
• Signed 16
201