Table 55 Hoa Feedback Signal Tab Parameters - Honeywell HC900 Reference Manual

Function Blocks
HOA Hand/Off/Auto Switch Function Block
FEEDBACK SIGNAL tab
The feedback signal is used for display purposes.
When the HOA block is used in conjunction with a Device Control (DC) block, the feedback is typically
referenced to the (STI) status output pin of the DC block. The sample text shown in
correspond to the states of the DC block.
To select a Feedback signal and to define state text for the enumerated value of the feedback signal,
proceed with the sequence 1 through 3 below.
Sequence Parameter
Number Field
1
Analog Signal Tag List
2
Select/Delete Signal
174

Table 55 HOA feedback signal tab parameters

Action
Click on a signal
tag in the list
Click "Select" at
the bottom of
the "Analog
Signal Tag List"
to place
highlighted
signal tag into
the "Selected
Signal" field
HC900 Hybrid Control Designer Function Block Reference Guide
Selections
Select from all configured
Analog Signal tags listed
T able 55 would
H
Comments
The selection is
placed in the
Selected Signal field
on the dialog box.
Click on "Delete
Signal" at the bottom
of the "Analog Signal
Tag List" to remove
a signal tag from
field.
Revision 11
2/07