How To Select Time Format, Set Local Time; How To Take A Screenshot Of The Display - Furuno FMD-3200 Operator's Manual

1. INTRODUCTION
1.13

How to Select Time Format, Set Local Time

The time indication on the Status bar shows either UTC time and date, or on-board
time and date, and cannot be adjusted. On-board time display requires synchroniza-
tion with the on-board clock. For further details, consult your local dealer.
You can switch between the local time and the UTC time by left-clicking the Current
time format indication (requires synchronization with local time, consult your local
dealer for details).
Note: The date and time are yellow when the ZDA sentence is lost.
Current time format
Left click: Switch time
between local and UTC.
Right click: Adjust local time.
To set the local time, enter the time difference between the local time and the UTC
time as shown below.
Note: Where the on-board time is synchronized, the local time setting is not available.
1. Right-click the Current time format indication to show the context-sensitive menu
then click [Adjust Local Time] to display the [Local Time Adjust] dialog box.
2. Enter the time difference between the local time and the UTC time, in hours and
minutes. Use the button on the left to select the time offset direction. Select "+" if
the local time is ahead of the UTC time, or "-" if it is behind the UTC time.
1.14

How to Take a Screenshot of the Display

Click the [Capture] button on the InstantAccess bar™ to take a screenshot and save
it to the SSD (Solid State Drive). You can save a maximum of 100 screenshots. When
the capacity for screenshots is reached, the oldest screenshot is automatically deleted
to make room for the latest. In this case, delete unnecessary screenshots. You cannot
take a screenshot when a menu or a dialog box is open. Screenshots can be copied
to a USB flash memory. For how to process screenshots, see section 23.11.
[Capture]
button
1-14
E E
Time