How To Turn The Power On/Off; The Standby Mode - Furuno FMD-3200 Operator's Manual

1. INTRODUCTION
1.3

How to Turn the Power On/Off

Normally, leave the power switches at the front of the Processor Unit on and control
the power with the power switch on a Control Unit (RCU-024, RCU-026). The monitor
unit is powered independently.
How to power the system
Push the Mains switch on the Processor Unit for the "I" position. Turn on the power
switch on the Processor Unit or a Control Unit. The start-up display appears on the
monitor.
Note: If the ambient temperature is less than 0°C (32°F) when the power is applied,
nothing appears on the display and the Status LED on the Control Unit flashes in
green. This is because the heater is warming the Processor Unit. The display appears
after the Processor Unit becomes warm, in approx. two minutes.
How to power off the system
Press the power switch on the Processor Unit or a Control Unit. Push the Mains switch
for the "O" position.
1.4

The Standby Mode

The standby mode, which requires a password to activate, deactivates the audio
alarms from the ECDIS. Use this mode when the ECDIS is not required, like in a har-
bor.
To go to the standby mode, first click the [OTHERS] button on the Status bar then click
[STANDBY]. Have the holder of the password enter the password then click the [OK]
button.
Click to return to normal operation.
To return to normal operation, click [Back to Normal Mode].
1-2
Enter password;
click OK button.