Exchanging the PCB-50 LED
2.5
(1) Removing
Grid detect sensor
Connector
1. After removing the connector connected with the PCB-50LED unit, loosen the screw (x2)
fixes the Grid detect sensor on the top cover and remove this screw.
2. Loosen the screw (x4) fixes the PCB-50 LED on the top cover and remove this PCB.
Note:
1. At the assembling, draw the cable carefully so as not to crowd.
2. Do not tighten the screw so much.
4. Repair Guide
Screw x2
Washer
PCB-50 LED
17
Screw x4
Spring Washer
Plane Washer
Alminium
Spacer