Canon CXDI-50C Service Manual page 101

(16) Tool Modes (/np mode)
1) Purpose
The tool modes (startup options) are intended in order to check operation, and are used
to launch the CXDI application on the control PC by itself, and to display items that are
not normally displayed.
2) Notes
The following operation must be performed before using the "/np" mode. Especially, be
sure to back up the exposure mode names and the customized settings before the
operation.
2-1) When using "/np" with the same settings as that of the connected sensor unit
"BodyPart**.ini" file can be used as it is.
Example:
Sensor1
Sensor2
2-2) In case of using "/np" with different settings from that of the connected sensor unit
Move the "BodyPart**.ini" file in the "BodyParts" folder to the desktop, etc.
However, do not move the Reference folder. If the "BodyPart**.ini" file is left in the
"BodyParts" folder, system will not be able to be started, as the sensor type of the
"BodyPart" and the settings do not match.
Example:
Sensor1
Sensor2
3) Preparation
3-1) Connect the keyboard and the mouse to the control PC.
3-2) Delete the "ccrstart.bat" file from startup.
3-3) Disconnect the imaging unit from the control PC.
4) Startup method
4-1) Start up Windows XP.
4-2) Start the Command Prompt screen.
Start ⇒ Program ⇒ Accessories ⇒ Command Prompt
4-3) Command Prompt screen appears, type the commands following instruction below to
start the CXDI application. (Press the [Enter] key after typing the command.)
No. Command Prompt
1 C:\>
2 D:\>
3 D:\ccr>
4-4) If the message "Sensor not connected" appears at starting of the CXDI application,
click [OK] button, Change to the "Debugging mode" with the keys ([Alt] + [Tab])
using.
4-5) When Welcome to CCR appears, select "1. Set-Up...".
2. Installation Manual
Connection
Table
Stand
Connection
Table
Stand
Command
D:
"Space" delimiter is required between
cd ccr
"cd" and "ccr".
"Space" delimiter is required between
ccrxxxxx /np "xxxxx" and "/".
"xxxxx" is different in version.
- 84 -
/np setting
Table
Stand
/np setting
Table
Stand
Note.