Canon CXDI-50C Service Manual page 159

3 P C B S e t t i n g s
3 P C B S e t t i n g s
(1) Sensor Unit
1) PWB-50Di (BG7-2999)
<SW1>
SW1
1 OFF
2 OFF
3 OFF
4 OFF
5 OFF
6 OFF
7 OFF
8 OFF
<SW2>
SW2
1 ON
2 OFF
3 ON
4 ON
5 ON
6 OFF
7 ON
8 OFF
- Product type should be "a". Since Firmware Ver.2.00.05 and later identifies the product type (CXDI-
50G/50C) from Sensor serial No.
- Sub No. by product type: The setting 1-4 of SW2 is identified.
- Sub No. by product type "2" indicates the gold-plating connector, and is used with FFC plated with gold.
Please note that it is incompatible with that of the sub number "1" used for former CXDI-50G.
4. Repair Guide
SW4
SW1
SW2
Not used.
Starts the Initialize code by force ON: Yes OFF: No
SW1-2 ON Ether Setting FlashROM Read
ON: Yes OFF: No
Not used.
Not used.
Not used.
Detects cable length automatically ON: Disable OFF: Enable
SW1-7 ON ON:3m OFF:7m
Sub No. by Product type "2"
-It changes when PCB is changed, etc.
Not compatible with that of sub No."1"
Product type "a"
24
Function
Function