Canon CXDI-50C Service Manual page 51

(3) Installing Firmware and PLD Code
1) Purpose
Write exposure code and PLD code into the Flash ROM of the PWB-50Di in the imaging
unit.
2) Notes
Be sure to check that the CXDI is connected to the system.
3) Procedure
3-1) Installing the firmware
Write the firmware by referring to "Firm Write Tool Software (Firmwrite.exe)" in the Tool
Software Operation Manual for Ethernet.
Where to write: IC1 (Flash ROM) on PWB-50Di
3-2) Installing PLD code
Write PLD code by referring to "PLD Write Tool Software (pldwrite.exe)" in the Tool
Software Operation Manual for Ethernet.
Where to write: IC11 (PLD) on PWB-50Di.
2. Installation Manual
- 34 -